Setting the Ethernet interface control
Procedure
1. Press Main Menu > Admin.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Use the Down Arrow to select Network interface.
5. Use the Right Arrow key to change Network mode to Ethernet and do one of the
following settings:
• Network config: To change the network configuration to either Auto or Manual.
• Ethernet: To change the Ethernet setting, go to step 6.
• PC Ethernet: To change the PC Ethernet setting, go to step 7.
6. Use the Right Arrow key or the Toggle soft key to change the Ethernet setting to one of
the following:
• Auto
• 10Mbps half
• 10Mbps full
• 100Mbps half
• 100Mbps full
7. Use the Right Arrow key or the Toggle soft key to change the PC Ethernet setting to one
of the following:
• Auto
• 10Mbps half
• 10Mbps full
• 100Mbps half
• 100Mbps full
• Disabled
8. Press Save.
Group identifier
A group identifier is a number assigned to a particular community of IP phone users in an
organization. The group identifier number can be a number from 0 to 999 and the default number
is 0.
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 82
Comments on this document? infodev@avaya.com
To Next Page
Loading...
