User experience when redundancy is configured
When the phone is configured for redundant signaling service (primary and secondary servers), it
notifies to the user in the following cases:
• There is no signaling service available from either primary or secondary servers. The phone
will try to connect these servers and once services from any server are available, the user
can log in and the phone becomes available for service.
• Signal delays are encountered on conditions such as the server is busy or the phone is
retrying signaling service on a secondary server when the primary is unavailable.
Related links
User interface notification parameter on page 283
User interface notification parameter
Set the following parameter in the 46xxsettings.txt file to control the UI notification during
making a call:
Parameter name Default value Description
WAIT_FOR_CALL_OPERATION_
RESPONSE
3 Specifies the time in seconds
before providing a response for
user initiated call operation.
Note:
It is recommended that this
parameter should be left to the
default value.
Related links
User experience when redundancy is configured on page 283
User experience when redundancy is configured
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 283
Comments on this document? infodev@avaya.com
To Next Page
Loading...
