Avaya J100 Series Installing And Administering

3. In the Address field, enter the IP address of the phone.
4. In the SNMP MIBs list, double-click the PHONEKEYLIST parameter to view its value.
The MIB browser application displays the parameter value in Result Table on the right, in
the Name, Value and Type columns.
Related links
Viewing IP address of the phone on page 96
Phone screen width
The phone screen width can be either forced or configured as a default layout which can the user
can change later in the Settings menu of the phone.
The phone screen width is set in either of the following ways:
• by configuring the PHONE_SCREEN_MODE parameter in the 46xxsettings.txt file
• by enabling the required mode in the web interface
Related links
Settings field descriptions on page 127
Phone screen width configuration
Configure the following parameter in the 46xxsettings.txt file for setting the default screen
width on the phone.
Important:
If the user has selected Half Screen mode in the Settings menu, changing
PHONE_SCREEN_MODE from 0 to 1 will have no effect.
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 242
Comments on this document? infodev@avaya.com

Avaya J100 Series Specifications

General

Category	IP Phone
Speakerphone	Yes
Connectivity	Ethernet
Power	Power over Ethernet (PoE)
Network Protocols	SIP
Display	Monochrome or Color (depending on model)