Avaya J100 Series - Configuring Multicast Paging

Name Description
Exchange Server Secure Mode Specifies the exchange server mode.
The options are:
• HTTP
• HTTPS (default)
Configuring Multicast Paging
About this task
Use this procedure to enable or disable Multicast Paging on the phone and configure the settings
for transmission.
Procedure
1. Log in to the web interface as an administrator.
2. In the navigation pane, click Multicast Paging.
3. In the Multicast Paging tab, configure the following fields:
• Multicast Paging State
• Multicast Paging Codec
4. Configure the incoming and outgoing paging groups in the following sections:
• Multicast Paging Groups To Listen
• Multicast Paging Groups To Send
5. Click one of the following:
• Save: To save the changes.
• Reset to Default: To revert to the default values.
Related links
Multicast Paging on page 233
Multicast Paging configuration on page 234
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 168
Comments on this document? infodev@avaya.com