5 (Optional) Attach the button module to the
phone.
Note:
JBM24 Button Module and Avaya
J100 Expansion Module are
supported only by Avaya J169/J179
IP Phone.
Button modules on page 16
6 Determine the open SIP operation mode
that you want to configure the Avaya J100
Series IP Phones.
Open SIP operation modes on page 40
7 Review prerequisite information and
gather the pre-configuration data.
8 Set up the Provisioning Server. Provisioning Server configuration on
page 30
9 Connect Avaya J100 Series IP Phones to
the power supply and network with the
Ethernet cable.
Power specifications on page 19
10 Perform the phone initialization following
the tasks for one of the selected methods.
Phone initialization on page 37
Hardware installation
Installing the wireless module
Before you begin
Obtain the following items:
• Phillips #1 screw driver to install the screw of the Avaya J100 Wireless Module.
• A flat screw driver that fits in the opening of the module panel.
Procedure
1. Insert the screw driver in the opening of the module panel to release the latch. Do not pry
open the panel.
Hardware installation
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 23
Comments on this document? infodev@avaya.com
To Next Page
Loading...
