Avaya J100 Series Installing And Administering

With a group identifier, you can provide administration settings to each phone used by different
communities of end users. For example, you might want to group users by time zones or work
activities.
You can configure group identifier from the phone UI as a local administration process.
You can set the group values from the System Manager and Communication Manager via
Personal Profile Manager (PPM).
Setting the group identifier
About this task
Use this procedure to set or change the group identifier only if the LAN Administrator instructs you
to do so.
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select Group.
5. Enter any Group value between 0 to 999.
When you change the Group value, the phone restarts after you exit the admin menu.
6. Press Save.
Setting event logging
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select Log.
5. Use the Right and Left Arrow keys to select one of the following settings associated with
the corresponding SYSLOG_LEVEL:
• Emergencies: SYSLOG_LEVEL=0
• Alerts: SYSLOG_LEVEL=1
• Critical: SYSLOG_LEVEL=2
• Errors: SYSLOG_LEVEL=3
• Warnings: SYSLOG_LEVEL=4
• Notices: SYSLOG_LEVEL=5
Configuring the phone using Administration menu
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 83
Comments on this document? infodev@avaya.com

Avaya J100 Series Specifications

General

Category	IP Phone
Speakerphone	Yes
Connectivity	Ethernet
Power	Power over Ethernet (PoE)
Network Protocols	SIP
Display	Monochrome or Color (depending on model)