Parameter name Default value Description
SHORTCUT_ACTION_AUTODIAL
If ENABLE_BLIND_TRANSFER is set
to 1, the user can select between these
transfer types. If
ENABLE_BLIND_TRANSFER is set to
0, the user can make only an attended
transfer.
• 2: the active call is immediately
transferred to the destination. If this
value is used, it overrides the
ENABLE_BLIND_TRANSFER
parameter value.
• 3: the active call is put on hold, and the
call is established with the destination to
set up a conference.
• 4: the active or the held call is parked to
the destination by appending the Park
FAC with the destination extension
number.
Note:
This value (“4”) is supported only in
the Broadworks environment.
Active call soft key configuration
This feature allows you to configure soft keys that can be used during an active call to activate in-
call features with the help of DTMF. Using soft keys allows users to avoid remembering and
entering digital codes to activate in-call features.
You can configure this feature through the web Interface or in the 46xxsettings.txt file. You
can configure up to 10 soft keys for in-call features.
Note:
IP Office in CCMS mode does not support this feature.
Configuration of DTMF soft keys in the 46xxsettings.txt file
Each soft key has a set of attributes that can be configured for the SOFTKEY_ACTIVE parameter:
• type: key type, mandatory
• action: dialing sequence, mandatory
• label: soft key label, optional
Configuration of DTMF soft keys through Web Interface
You can configure active call soft keys in the Softkey Configuration > Active Call Softkey
Configuration tab of the web Interface. The following settings are available:
• Key: numeric, read-only
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 194
Comments on this document? infodev@avaya.com
To Next Page
Loading...
