Wireless Module configuration
You can configure a Wi-Fi network by:
• Setting Wi-Fi parameters in the 46xxsettings.txt file
• Configuring Wi-Fi parameters through the phone UI
• Configuring Wi-Fi parameters through the web UI
Note:
VLAN and LLDP functionalities are not supported over a wireless network.
Wall mounting Avaya J100 Series IP Phones
About this task
The wall mount kit is not bundled with the phone package. You must separately purchase the wall
mount kit that is unique to your phone model. Use the following part numbers to order the wall
mount kit:
• J129 phones — 700512707.
• J139, J159, J169, J179, and J189 phones — 700513631.
Before you begin
Obtain the following items:
• Wall mounting kit, containing a wall mount bracket, and an Ethernet cable.
• Four #8 screws. The screws are not provided with the wall mounting kit. If the wall plate is
pre-installed, you do not need the screws.
Procedure
1. Do one of the following:
• Place the bracket on the wall and mark to drill holes. Use the #8 screws to fix the
bracket.
Initial setup and connectivity
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 26
Comments on this document? infodev@avaya.com
To Next Page
Loading...
