Field name Description
Port The port the STUN server uses. For example, 3478.
If the STUN server is not configured, or the resolution has failed, the value is
null (“0”).
Protocol The protocol the STUN server uses. The possible values are:
• UDP: displayed when the STUN server is configured, and the resolution
through the DNS server is successful.
• Unknown: displayed when the STUN server is not configured, or the
resolution through the DNS server has failed.
Setting the 802.1x operational mode
Before you begin
• Make sure your RADIUS server and layer-2 network switch is configured properly for 802.1x
authentication.
• If you require EAP-TLS, install the identity certificates need on the phone beforehand.
• You can also enable 802.1x on the phone settings file, using DOT1XSTAT parameter. If you
use the settings file to configure 802.1x, make sure to align this change with layer-2 switch
and the RADIUS server. You can perform this step in a staging environment, before
deploying the phones for production use.
Warning:
Improper configuration of this feature can result in site-wide outage of IP phones.
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select 802.1X.
The phone displays the following settings:
• Supplicant
• Pass-thru mode
5. Select the setting that you want to change.
6. Press the Change soft key or the Left and Right Arrow keys to cycle through the
following settings:
• for the 802.1x Supplicant:
- Disabled: 802.1x Supplicant is disabled.
- Unicast: 802.1x Supplicant is enabled and works in unicast mode.
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 92
Comments on this document? infodev@avaya.com
To Next Page
Loading...
