Avaya J100 Series - Identifying the Device Type During Phone Boot-Up; Post Installation Checklist

3. Reboot the phone. The expansion module will reboot automatically.
Identifying the device type during phone boot-up
About this task
Procedure
1. Set up the phone hardware.
2. Plug the Ethernet cable to the phone.
The phone powers up and starts to initialize.
The phone screen displays one of the following message on Avaya J129 IP Phone:
•
Starting... Avaya SIP
•
Starting... Open SIP
The phone primary screen displays one of the following as the backsplash screen:
• A screen with Avaya text for Avaya SIP phones
• A screen with Open SIP text for Open SIP phones
Post installation checklist
To ensure that the phone is properly installed and running properly, verify that the following
requirements are complete.
No.
Task Reference
1 Has the phone acquired an IP
address?
2 Are you able to make a call from the
phone?
3 Are you able to perform backup-
restore?
3 Are you able to modify the phone's
Settings file parameters and end user
settings.
Configuration parameters on
page 292
4 Are you able to upgrade your phone? Device upgrade process on
page 286
5 Have you installed the appropriate
private network authentication
certificates?
Maintenance
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 288
Comments on this document? infodev@avaya.com