Avaya J100 Series - Turning a Normal Call Into a Conference; Adding Another Party Using Hold

• 802.1X
• Signaling
• Web server
Note:
When changed, some of the parameters require the phone reboot after exiting the
Administration menu or immediate reboot. You will get the notification when configuring the
parameters which need the phone reboot.
Accessing the Admin menu during phone startup
Before you begin
Ensure you set the following parameters in the Settings file:
• PROCSTAT: To administer the phone using admin menu, set the parameter to zero.
• PROCPSWD or ADMIN_PASSWORD: The default password is 27238. You must change the
default password at the time of initial installation.
Procedure
1. Press Main Menu soft key.
2. On the Access code screen, enter the admin menu password using the dialpad.
3. Press Enter.
Accessing the Admin menu after log in
Procedure
1. Navigate to Main Menu > Administration.
2. In the Access code field, enter the administration password.
The default access code is 27238.
3. Press Enter.
Accessing the Ethernet IPv4 settings
Procedure
1. Navigate to Main Menu > Administration.
2. In the Access code field, enter the administration password.
The default access code is 27238.
3. Press Enter.
Configuring the phone using Administration menu
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 79
Comments on this document? infodev@avaya.com