Avaya J100 Series Installing And Administering

020 1 Call X from Contacts list Phone sends an invite
message with
2741018989 and does
not insert the local area
code.
Null 1 Call X from Contacts list Phone sends an invite
message with
2741018989 and does
not insert the local area
code.
Restarting the phone
Procedure
1. Press Main Menu > Admin.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select Restart phone.
5. Press Restart when the phone prompts for confirmation.
A restart does not affect user-specified data and settings, such as contact data or the
phone login and password.
Configuring Wi-Fi using phone UI
About this task
Use this procedure to configure a Wi-Fi network by using phone UI. Note that switching networks
causes a reboot of the phone.
Procedure
1. Navigate to Main Menu > Administration.
2. In the Access code field, enter the administration password.
The default access code is 27238.
3. Press Enter.
4. Select Network Interfaces.
5. Use the right arrow key to change Network mode to Wi-Fi.
6. Configure the following parameters:
• Network config: Specifies if the WLAN is connected automatically or manually.
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 86
Comments on this document? infodev@avaya.com

Avaya J100 Series Specifications

General

Category	IP Phone
Speakerphone	Yes
Connectivity	Ethernet
Power	Power over Ethernet (PoE)
Network Protocols	SIP
Display	Monochrome or Color (depending on model)