- Multicast:Supplicant is enabled and works in multicast mode.
• For the Pass-thru mode:
- On: 802.1x packets from the PC port are forwarded to and from the layer-2 switch
connected with the phone’s LAN interface.
- On & proxy logoff: 802.1x packets from the PC port are forwarded to and from the
layer-2 switch connected with the phone’s LAN interface. The phone sends an EAP-
Logoff when PC is disconnected.
- Off: 802.1x forwarding is disabled between PC port and the network switch. Do not
select this option is PC is authenticated over 802.1x
7. Press Save.
When you change the 802.1X data, the phone restarts after you exit the administration
menu.
Updating phone settings and firmware
About this task
Use this procedure to apply new settings from the file server or, if available, upgrade the phone
firmware to a new version.
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the Administration menu password.
3. Press Enter.
4. Scroll to Get updates, and press Select.
The phone displays the Update may require a phone reboot notification.
5. To apply the new settings or upgrade the phone to a new firmware version, press Update.
If the file server contains the new settings which do not require a phone reboot, the
Administration menu reappears. If there are new settings requiring a reboot or a new
firmware version available, the phone reboots.
6. To exit the menu without applying the updates, press Cancel.
Resetting system values
About this task
Use this procedure to reset all system initialization values to the application software default
values.
Configuring the phone using Administration menu
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 93
Comments on this document? infodev@avaya.com
To Next Page
Loading...
