Push-To-Talk
With the Push-To-Talk feature, a user can call another user and have the call answered
automatically. This feature can be configured as a one-way or a two-way media connection.
The Push-To-Talk feature can also be configured when Automatic Answer is enabled.
The feature can be configured on BroadSoft web interface and by setting the required parameter
in 46xxsettings.txt file.
For more information about configuring Push-To-Talk on BroadSoft web interface, refer to Push-
To-Talk Feature Description at
https://www.broadsoft.com/.
Push-To-Talk configuration
Use the 46xxsettings.txt file to set the following parameter for having a Push-To-Talk
incoming call automatically answered:
Note:
Disabling this setting will affect other features like Call Unpark.
Parameter name Default value Description
AUTO_ANSWER_MUTE_ENABL
E
1 Controls the speakerphone
muting when call is auto
answered by the phone.
Value operation:
• 0: Speakerphone is unmuted
when the call is auto answered.
• 1(Default): Speakerphone is
muted when the call is auto
answered.
Pre-configuration of keys
With the Pre-configuration of keys feature, you can configure a set of phone keys for accessing
features, applications or line appearances. You can also add BLF lines and set autodialing with
this feature. The configured keys can be labelled as required.
Pre-configuration of keys is configured per user, and it is applied to all the phones used by that
user.
This set of keys is pre-determined and becomes available after the software installation on the
Phone screen. If the phone key configuration is not forced, the user can change key mapping and
labels as required, and these changes will override the configuration set by the system
administrator.
Feature configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 239
Comments on this document? infodev@avaya.com
To Next Page
Loading...
