transmission, the phone does not display any incoming calls but shows a message box indicating
there is an outgoing multicast page. The user can activate any available audio device to send a
page. The transmission is handled in a way similar to the outgoing call procedure.
If there is an incoming multicast page transmission with a higher priority, all other transmissions,
including lower-priority pages and incoming calls, are ignored. Active calls have the priority level 3
and are put on hold when a multicast page with a higher priority is transmitted.
The Multicast Paging can be configured in either of the following ways:
• by setting the relevant parameters in the 46xxsettings.txt file
• by defining the group list in the web interface
Multicast Paging does not depend on the SIP server and can be configured independently.
However, the network used for Multicast Paging configuration must support multicast
transmission. This feature is supported in all the environments.
Related links
Configuring Multicast Paging on page 168
Multicast Paging configuration on page 234
Multicast Paging configuration
Use the 46xxsettings.txt file to set the following parameters for the Multicast Paging (MP)
feature:
Parameter name
Default value Description
MP_ENABLED 0 Specifies if the Multicast Paging
feature is enabled on the phone.
This is the basic parameter for
this feature. If this parameter is
not set, other parameters listed
below will be ignored.
Valid values:
• 0: Multicast Paging is disabled.
• 1: Multicast Paging is enabled.
Table continues…
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 234
Comments on this document? infodev@avaya.com
To Next Page
Loading...
