Avaya J100 Series Installing And Administering

Multicast Paging field description
Name Description
Multicast Paging State Specifies whether the Multicast Paging feature is
enabled on the phone. If Multicast Paging state is
not set, other settings related to the feature will be
ignored.
The options are:
• Enable
• Disable (default)
Multicast Paging Codec Specifies a codec which will be used in Multicast
Paging transmissions.
The options are:
• G.729 (default)
• G.711u
• G.711a
Multicast Paging Groups To Listen If the Multicast Paging feature is enabled, you can
add, edit or delete incoming multicast page groups
in this section.
The configuration fields are equivalent to the
MP_GROUPS_TO_LISTEN value:
• IP: the multicast IP address of the group
• Port: the IP port of the Multicast Paging group.
The valid value is an even integer from 1024 to
65534.
• Priority: the group priority
• Label: the group label which the phone displays
when the incoming page is played
Multicast Paging Groups To Send If the Multicast Paging feature is enabled, you can
add, edit or delete outgoing multicast page groups
in this section.
The configuration fields are equivalent to the
MP_GROUPS_TO_SEND value and control the
same settings as Multicast Paging Groups To Send
fields.
• IP
• Port
• Label
Related links
Multicast Paging configuration on page 234
Configuring the phone using the web interface
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 169
Comments on this document? infodev@avaya.com

Avaya J100 Series Specifications

General

Category	IP Phone
Speakerphone	Yes
Connectivity	Ethernet
Power	Power over Ethernet (PoE)
Network Protocols	SIP
Display	Monochrome or Color (depending on model)