• By setting the required parameter in the 46xxsettings.txt file.
Enabling access to the web interface through the Administration menu of
the phone
About this task
On the web interface of the phone, you can:
• Configure the parameters of the phone.
• View the status of the configurations.
The web interface access is active by default. Use this procedure for subsequent enabling.
Procedure
1. On the phone, press Main menu.
2. Scroll to Administration, and press Select.
3. In the Access code field, enter the administration password.
The default access code is 27238.
4. Press Enter.
5. Scroll to Web Server, and press Select.
6. Scroll to Web on HTTP, and press Toggle to Yes.
7. Press one of the following:
• Save
• OK
Web interface access through the settings file
Use the 46xxsettings.txt file to set the following parameter to enable or disable access to the
web interface:
Parameter
Default value Description
ENABLE_WEBSERVER 0 Specifies whether the HTTP or
HTTPS web server is enabled or
disabled.
The options are :
• 0: Disable
• 1: Enable
Viewing IP address of the phone
About this task
Use this procedure to obtain the IP address of the phone to log in to the web interface.
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 96
Comments on this document? infodev@avaya.com
To Next Page
Loading...
