Avaya J100 Series - Page 215

Call Forwarding configuration
Use the 46xxsettings.txt file to set the following parameters:
Parameter name Default value Description
CALLFWDADDR — Sets the address to which the
calls are forwarded.
Users can change or replace this
administered value if
CALLFWDSTAT is not 0.
Note:
This parameter is supported
when failed over from Aura
SM to a non-Aura survivable
server, excluding BSM.
CALLFWDDELAY — Sets the number of ring cycles
before the call is forwarded to the
forward or coverage address. The
default delay is one ring cycle.
CALLFWDSTAT 0 Sets the call forwarding mode of
the phone by totaling? the
following values:
• 0: Disables call forwarding.
• 1: Permits unconditional call
forwarding.
• 2: Permits call forward on busy.
• 4: Permits call forward/no
answer.
Example: If you set a value of 6,
the phone enables call forwarding
on a busy tone and on no answer.
Note:
This parameter is supported
when failed over from Aura
SM to a non-Aura survivable
server (excluding BSM).
Table continues…
Feature configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 215
Comments on this document? infodev@avaya.com