Avaya J100 Series - Page 452

Parameter name Default value Description
SIP Transport UDP 0 Determines whether SIP
Transport = UDP can be
manually configured on
the phone.
Valid values are:
• 0 for No
• 1 for Yes
Note:
This parameter is
supported for 3PCC
environment.
SIPCONFERENCECONTINUE 0 Specifies if a conference
call continues after the
host hangs up.
Value operation:
• 0: Drop all parties.
• 1: Continue conference
Note:
This parameter is set to 1
in IP Office environment.
SIPDOMAIN Null Specifies the domain
name to be used during
SIP registration.
The value can contain 0 to
255 characters. The
default value is null.
SIPPORT 5,060 Specifies the port the
phone opens to receive
SIP signaling messages.
Valid values are 1,024
through 65,535. The
default value is 5,060.
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 452
Comments on this document? infodev@avaya.com