Avaya J100 Series - Page 457

Parameter name Default value Description
SLMSTAT 0 Specifies if the SLA
Monitor agent is enabled
or not.
Value operation:
• 0: Disabled (default)
• 1: Enabled in listening
mode
• 2: Enabled in active
discovery mode, used
for remote worker
deployments
SNMPADD Null Specifies a list of source
IP addresses from which
SNMP query messages
will be accepted and
processed.
Addresses can be in
dotted-decimal format
(IPv4), colon-hex format
(IPv6, if supported), or
DNS name format,
separated by commas
without any intervening
spaces.
The list can contain up to
255 characters. The
default value is null.
SNMPSTRING Null Specifies a security string
that must be included in
SNMP query messages
for the query to be
processed.
Valid values contain 0
through 32 ASCII
alphanumeric characters.
The default value is null.
Null disables SNMP.
Table continues…
List of configuration parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 457
Comments on this document? infodev@avaya.com