Parameter name Default value Description
VLANSEPMODE 0
1 for J129
Specifies whether full
VLAN separation is be
enabled by the built-in
Ethernet switch while the
telephone is tagging
frames with a non-zero
VLAN ID. This VLAN
separation is enabled
when: VLANSEP=1,
L2QVLAN and
PHY2VLAN have non-zero
values, L2Q is auto (0) or
(1) tagging.PHY2PRIO is
not supported when
VLANSEPMODE is 1.
Value operation:
• 0: Disabled
• 1: Enabled
Note:
This parameter is
configured through
the settings file.
VLANTEST 60 Specifies the number of
seconds that the phone
waits prior to failing back
to a different VLAN ID if no
response is received from
the DHCP server.
Valid values are 0 through
999.
A value of zero means that
DHCP tries with a non-
zero VLAN ID forever.
Note:
This parameter is
configured through:
• Settings file
• A name equal to
value pair in
DHCPACK
message
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 476
Comments on this document? infodev@avaya.com
To Next Page
Loading...
