Avaya J100 Series - Page 486

Parameter Name Default Value Description
WLAN_WPA2E_EAP_PHASE2 N/A Specifies the pre-configured Wi-Fi
network 802.1x phase 2 Method.
This parameter is only applicable
when WIFISTAT enables Wi-Fi
and WLAN_SECURITY is wpa2e
and
WLAN_WPA2E_EAP_METHOD
is PEAP.
Value operation:
• none- No phase 2
authentication (Default, but not
currently supported)
• MSCHAPV2 : set to this value
for forward compatibility
Note:
Avaya J129 IP Phone, Avaya
J159 IP Phone, and Avaya
J179 IP Phone support a
pluggable Wi-Fi/BT module
WLAN_WPA2E_ANONYMOUS_I
DENTITY
Null Specifies the pre-configured Wi-Fi
network 802.1x anonymous
identity. This parameter is only
applicable when WIFISTAT
enables Wi-Fi and
WLAN_SECURITY is wpa2e and
WLAN_WPA2E_EAP_METHOD
is PEAP and
WLAN_WPA2E_EAP_PHASE2 is
MSCHAPV2.
The value can contain 1 to 32
characters; Valid characters are:
A-Z, a-z, 0-9, and the following:
*.-!$%&'()+,:;/\=@~ The space
character, ASCII 0x20, is NOT
supported.
Note:
Avaya J129 IP Phone, Avaya
J159 IP Phone, and Avaya
J179 IP Phone support a
pluggable Wi-Fi/BT module
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 486
Comments on this document? infodev@avaya.com