Avaya J189 - Logging in to your phone

• Never: To never prompt for the provisioning server address.1
• Cancel: To cancel the prompt and display the Login screen.2
3. After you press Config, enter the provisioning server address in the Address field.3
The address is an alphanumeric URL. For example, http://myfileserver.com/4
j100/.5
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric soft key to toggle to the 6
ABC mode.7
To enter the forward-slash symbol (/) in the field, press the / soft key.8
4. (Optional) Enter the Group number.9
Obtain the Group number from your system administrator. The value ranges from 0 to 999. 10
If you do not enter a value, the phone uses the default value of 0.11
5. Press Save.12
The phone continues the boot process and connects to the provisioning server.13
Identifying the device type during phone boot-up14
About this task15
Avaya J100 Series IP Phones screen displays the device type during the phone boot-up. This 16
feature is supported from the phone software version 4.0.3 and later.17
Procedure18
1. Set up the phone hardware.19
2. Plug the Ethernet cable to the phone.20
The phone powers up and starts to initialize.21
The phone backsplash screen displays Avaya text.22
Logging in to your phone23
Before you begin24
Your extension and password are provided by your administrator.25
Procedure26
1. On the Login screen in the Username field, type your extension.27
Identifying the device type during phone boot-up
October 2022 Using Avaya J189 SIP IP Phone in Avaya Aura
®
23
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
DRAFT—October 5, 2022—8:17 AM (UTC+00:00)