PAGE 68
Windows PC Software
• With the option Encoder follows Decoder on incoming calls you ensure
that the Encoder always works with the same settings (such as e.g. Audio
coding algorithm and sampling frequency) as the Decoder does.
MPEG Mode
Identical settings as under Transmission Modes
→ MPEG Mode (see PAGE
62).
Ancillary Data (ISO/MPEG)
Identical settings as under Transmission Modes → Ancillary Data
(ISO/MPEG) (see PAGE 63).
Data Channel 1/2 (J.52)
Identical settings as under Transmission Modes → Data Channel 1/2 (J.52)
(see PAGE 63).
3
If you select G.722 (7-kHz), the system signals to the remote side that only a 7-kHz Decoder is
available, also you have an MPEG Decoder with MAGIC AC1. In this way, the remote side is
forced to encode with 7-kHz.
TIP
Since some Audio Codecs only allow the same parameters in transmit and re-
ceive direction, this setting should be always enabled to guarantee maximum
compatibility.
This setting only refers to incoming calls. If you establish a connection yours-
elf, you can select different parameters for Encoder and Decoder if the called
end supports the configuration.
To Next Page
Loading...
