baxter Hillrom Progressa - Page 61

Graphical Caregiver Interface (GCI) Controls
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 49
The Room and Patient icons on the Home screen tells you the status of the association and also permits
you to associate a room and patient to the bed.
Set Up the Bed Association Using the Room/Patient Icon
Home Screen
Room/Patient
Icons
Description
No room associated; no patient verified
Room associated; no patient verified
a
a. The Patient icon flashes when a patient is available from the gateway but has not yet been verified.
Room associated; patient verified
Transport Screen Description
If the bed is plugged in after being unplugged, the Bed
Location screen will show and stay on the screen until the
question is addressed.
There are two ways to associate a room and its patient to
the bed through the GCI screen:
• “Set Up the Bed Association through the
Settings/Preference Menu” on page 50
•“” on page 52
1. At the Home screen, press the applicable Room or
Patient icon.
2. Select the correct options for the location, such as
Building, Floor, and Room number.
NOTES:
• The location selection screens may have up to
five levels of hierarchy: facility, building, unit,
floor, and room. The Other Location control
allows you to scroll through the available location
levels.
• On the Available rooms screen, if you press the Associated rooms control, a list of rooms that
are associated to other beds will show.