Graphical Caregiver Interface (GCI) Controls
52 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
Override the Room to Bed Association
If the room already has a bed associated, make sure that you try to assign the bed to the correct room.
If necessary, use the steps that follow to override the association:
You cannot override the association of a bed that is connected to a 37-pin connection.
1. When you plug in the bed after you enter a room and
select the last Patient Room on the Bed Location
screen, it will show that another bed is associated to
the room. If you are sure that this is the room you are
in, press Continue.
2. You will be asked to verify the patient identity, you
have these options:
• Continue—press this control if you want to verify
the patient. See “Verify the Patient Identity” on
page 53.
• Cancel—press this control if you do not want to
verify the patient and return to the Home screen
will show.
• Change Room—press this control to associate a different room to the bed. The bed will
retrieve room data, and then the Building screen will show. Select the Building, Floor, and
Room number.
3. Press Yes to verify the patient. Otherwise, press
Cancel to go to the Home screen.
When a bed association is overridden, the overridden
bed will sound a repeating audible tone and the Bed
Location Overridden screen will show until you
respond. The overridden bed can then be associated
to the correct room. The Associate control will show
the available rooms.
To Next Page
Loading...
