Graphical Caregiver Interface (GCI) Controls
50 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
Set Up the Bed Association through the Settings/Preference Menu
• You may see a “Retrieving Data” screen as the bed gets the information from the Smart Bed
Connectivity.
3. The room location and patient identity screen will
show. Do as applicable:
• Continue—press this control if the room number
is correct and you want to verify the patient
identity. Go to “Verify the Patient Identity” on
page 53.
• Cancel—press this control if you do not want to
verify the patient identity. The Home screen will
show with the Room Associated icon and flashing
No Patient icon.
• Change Room—press this control if the room number is not correct. The Building screen will
show. Select the Building, Floor, and Room number.
4. After you select the room number, the bed will
retrieve the room data, then associate the room to
the bed. You will be asked to verify the patient
identity, you have these options:
• Ye s —press this control to verify and activate bed
location and patient. The bed will return to the
Home screen.
• No—press this control if the identity information
is not correct.
• Cancel—press this control cancel and return to the Home screen.
1. At the Home screen, press the Settings menu control.
2. Press Bed/Patient Locate.
To Next Page
Loading...
