140 - Settings
This operational mode allows you to configure MC6-T according to
your own needs and also, recalibrate MC6-T. The following settings/
configurations are available:
• Language for selecting user interface language.
• About. Information about installed modules, firmware options etc.
• Power Management for defining auto-off delays and display
brightness. See also chapter Power Management.
• Sound Volumes for setting volumes for different sounds MC6-T emits.
• Date & Time, including Time Zone selection and activating Daylight
Saving Time. This setting is synchronized with the computer when
communicating with CMX. See also chapter Mobile Security Plus
software option.
• Regional Settings for setting local net frequency and default values.
See also chapter Mobile Security Plus software option.
• Owner for entering owner information, shown in Home View.
• Controller Presets. Enabled if you have purchased controller
communication options. More in chapter Additional Information.
• Maintenance for recalibrating/adjusting MC6-T and setting calibration
date. Also for the possibility to align the Touch Screen.
• Documenting Calibrator. Settings related to instrument calibration,
e.g. is "Save as Both" allowed ("Save as Both" means a single
calibration run may be saved both as As Found and As Left calibration.)
Note: If an instrument is sent from CMX, then CMX is the
master system of these settings. In that case settings set in
the calibrator does not matter.
• HART, FOUNDATION Fieldbus and Profibus PA for defining
communication parameters to Digital Communication Instruments.
• Network for setting local area network parameters (for Beamex internal
use only).
• Temperature Block opens a window for configuring how the heating
and cooling is defined in the Temperature Block. This setting is also
available in Temperature Calibrator's menu, see chapter The Menu.
Each setting/configuration is self-explanatory once you have familiarized
yourself with MC6-T's user interface. Configuration screens often have a
menu option for recalling factory settings.
Note: MC6-T's calibration date can be set in Maintenance
configuration window under Change Module Data setting. PIN
code for setting the calibration date is 2010. PIN code for MC6-
T's Adjust Calibrator setting is device dependent and was
shipped together with MC6-T.
To Next Page