General - 39
Active Terminals and
Connections
Things discussed in this part:
• A presentation of measurements MC6-T is capable of performing. For
all measurements, the active terminals together with useful additional
information for that particular measurement are presented.
• Similarly, a presentation of generations and simulations MC6-T is
capable of performing.
• For generations/simulations, there is also information on how to change
the generated/simulated value.
General
This section of MC6-T User Manual presents all measurements and
generations/simulations that MC6-T is capable of performing. No matter
which of the available main functions you use in MC6-T, the connections
presented here apply.
Settings in Temperature Calibrator or Calibrator are saved, so that the
next time you measure, generate or simulate something, the previous
settings are available as defaults.
Note: In the event of Mains switch being switched off,
Temperature Block and R3 settings will not be available.
When you use Documenting Calibrator and select an instrument for
calibration, the instrument's settings (Quantity, Port etc.) are inherited to
the Calibrator subwindows (if the corresponding function is present and
powered on).
Respectively, when creating a new instrument in Documenting
Calibrator, the settings in Calibrator's subwindows are used as default
settings for the new instrument's input and output.
To Next Page