Safe delivery for service - 147
Service and transportation
instructions
Service of the MC6-T must only be performed by an authorized
representative. There are no user-replaceable parts within the device. Do
not open the enclosure!
Note: Whenever Mains cord must be replaced, select a cord
with correct rating and type. Mains cord must have a protective
earth.
Safe delivery for service
When sending MC6-T for service, place it in its original packing box, as
received upon the delivery from Beamex. In all other cases use 40 mm
softeners on all sides for safe delivery.
If your unit is equipped with the Accessory Holder Kit use the Back
Transport Support during transportation to protect rear structures of the
device. Slide the Back Transport Support into the Accessory Holder Kit
as shown in Figure 141: Back Transport Support attached in place for safe
delivery.
Note: Before sending the unit for service, remember to
remove the insert from the device and all accessories from the
Accessory Holder Kit.
To Next Page
Loading...