BEAMEX MC6-T - Page 6

vi - Table of Contents
Tools in MC6-T..................................................................... 135
Saving Configurations..................................................135
Viewing/Managing Configurations................................135
Beamex MC6 Fieldbus Configuration Viewer....................... 136
Uploading Configurations.............................................137
Linking Configurations to CMX.................................... 137
Settings................................................................................. 139
Settings overview...........................................................................139
Maintenance..........................................................................141
Replacing the mains fuses............................................................ 141
Overtemperature Protection Test Mode.........................................142
Cleaning instructions......................................................................143
Firmware Update............................................................................144
Recalibrating MC6-T...................................................................... 144
Disposal of Waste Electrical and Electronic Equipment................ 145
Beamex and WEEE..............................................................145
Service and transportation instructions............................147
Safe delivery for service................................................................147
Resetting MC6-T............................................................................149
Additional Information.........................................................151
User Defined Function Data.......................................................... 151
User Defined PRT/RTD Sensors..........................................152
General.........................................................................152
Callendar van Dusen Formula for PRTs......................154
ITS-90 PRT Sensor..................................................... 155
Factor........................................................................... 157
Check Sensor Conversion........................................... 158
User Defined Transfer Functions..........................................159
User Defined Pressure Units................................................ 161
User Defined Steps Calibration Points................................. 163
Controller Communication.....................................................164
What Can be Done With Controller Communication....165
Configuring Controller Communication........................ 166
Changing Controller During Calibration....................... 167
Index.......................................................................................................169