Becker Traffic Pro 7945 - Settings: Voice Output and Volume; Volume for Voice Output

125
Settings
Displaying voice settings
This function can be used to display the
currently valid voice settings.
X Select 6KRZVHWWLQJV in the voice mode
settings.
The voice settings are displayed.
•
00, ODQJXDJH indicates the current
setting for the display text language.
•
1DYL VSHDNHU indicates the current set-
ting for the navigation announcement
speaker.
•
6'6 indicates the current setting for
the voice dialogue system speaker.
•
776 indicates the current language
setting for reading out texts.
Volume for voice output
You can set the volume for announce-
ments from your Traffic Pro here.
X Select 9ROXPHRIYRLFHRXWSXW in the voice
mode settings.
X Select ,QGHSHQGHQWO\DGMXVWDEOH or 5HODWLYH
WRDXGLR
.
•
,QGHSHQGHQWO\DGMXVWDEOH
You can set the volume for announce-
ments independently of the volume set
for the audio source.
•
5HODWLYHWRDXGLR
The volume for announcements can be
set in a specific range based on the
volume set for the active audio source.
X For the 5HODWLYH WR DXGLR setting, select
9ROXPH.
X Turn the rotary control/push button
to select the required volume.
7006
Note:
Only one of the two settings may be
active ( ) at the same time.
7007
Note:
If you have previously selected
5HODWLYH
WR DXGLR
, you can set the volume in the
range between -10 and +10. In this case,
a negative value means that announce-
ments will be made more quietly than
the selected volume for the audio
source.
7008