Becker Traffic Pro 7945 - Settings: Voice Command Enhancements; Repeating Voice Announcements

127
Settings
• 6LJQDOSULRUWRYRLFHLQSXW
Once the function has been activated,
in addition to being highlighted on the
Traffic Pro, a beep tone sounds to
indicate that the unit is ready for a
voice command.
•
&RQILUPYRLFHLQSXW
If the function is active, the voice
command is repeated by the Traffic
Pro for confirmation. However, please
note that the voice command repeated
may not tally exactly with the voice
command you entered, but with the
main command. It may be the case, for
example, that you say “end” and the
Traffic Pro repeats “cancel”. In voice
mode, these two commands have the
same meaning.
•
'HWDLOHGYRLFHRXWSXW
If the function is active, in some places
you will receive detailed instructions
(e.g. for entering a destination in voice
mode).
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Extended PTT
If the function is active, voice mode can
be activated automatically by pressing
, , , * or
and you can input a voice command
directly.
X Select 377H[WHQGHG in the voice mode
settings.
X Turn the rotary control/push button
to switch the function on ( ) or off
().
Repeating a voice announcement
If the function has been switched on and
route guidance is active, the last naviga-
tion announcement can be repeated or an
updated navigation announcement out-
put by pressing .
X Select 5HSHDWYRLFHDQQRXQFHPHQW in the
voice mode settings.
X Turn the rotary control/push button
to switch the function on ( ) or off
().
Note:
The abbreviation PTT stands for “Push
To Talk”.
7012
7013
*Only available for the Traffic Pro with Bluetooth® wireless technology.