Becker Traffic Pro 7945 - Navigation Announcement Settings; Announcing Time of Arrival; ETA Setting Options

56
Navigation mode
• $QQRXQFHPHVVDJHV
If this function is active, all traffic
announcements are made automati-
cally on receipt.
•
2QURXWHRQO\
If you activate this function ( ),
only the traffic announcements rele-
vant to the route are made.
•
:DUQLQJVRQO\
Activate this function ( ) to have
only warnings announced.
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Announcing the time of arrival
You can specify whether the calculated
time of arrival should be announced
automatically once the route has been
calculated/ recalculated or after pressing
the button.
X In the Settings menu, select the
$QQRXQFHDUULYDOWLPH entry.
X Press the rotary control/push button
to switch the announcement of the time
of arrival on ( ) or off ( ).
ETA setting
You can configure the calculation of the
ETA. ETA stands for Estimated Time
of Arrival.
X In the Settings menu, select the (7$
VHWWLQJ
entry.
X Confirm your selection by pressing
the rotary control/push button .
X You may now select 6SRUWV FDU, &DU,
9DQ or 6HWIUHHO\.
•
6SRUWVFDU
This setting indicates to the Traffic Pro
that you tend to drive rather quickly.
An earlier ETA is calculated.
Note:
This setting must be active ( ) in order
to be able to activate the two other
settings.
2088
2091
2092