Becker Traffic Pro 7945 - Reset Settings; Mute

22
General operation
In this example you can see the settings
for the front loudspeakers.
X Turn the rotary control/push button
to select the required value.
Reset settings
You can reset all sound settings to the
default settings.
The following settings are reset to the
relevant default value:
•
(TXDOLVHU: All default settings are reset
to the initial value. The user-defined
setting is reset to zero.
•
%DODQFHIDGHU to centre setting
•
/RXGQHVV to off
• %HFNHUVXUURXQG to off
•
6XEZRRIHU to 0.
•
&URVVRYHU front and rear loudspeakers
to 50 Hz, subwoofer to 100 Hz.
X Select 5HVHW VHWWLQJV in the sound set-
tings.
X Select <HV to reset the sound settings
or
1R to continue without making any
changes.
Select
<HV to reset the sound settings.
Mute
You can switch your Traffic Pro to mute,
i.e. switch off the sound from the current
radio/media source.
However, navigation announcements,
traffic announcements (if TP has been
activated) and other voice announce-
ments on the Traffic Pro continue to be
transmitted unaffected.
X Press the rotary control/push button
and hold it down for at least
2 seconds.
Example of muted radio mode.
Example of muted media mode.
1026
1020
1021
1022