Becker Traffic Pro 7945 - Settings: Clock and Software Update; Clock Time Configuration; Software Update Procedure

133
Settings
Clock
You can configure the GMT time sent
by the satellite in terms of its format and
the current time zone.
The time needs to be set so that the
Traffic Pro can supply navigation
information correctly on routes with
time-dependent route guidance. Setting
the time also ensures that anticipated
times of arrival are announced/
displayed correctly.
X Select &ORFN in the system settings.
The Clock Settings menu appears. The
current time setting appears on the right-
hand side of the display.
X You may now select between &KDQJH
IRUPDW
, )RUZDUG  PLQXWHV and
%DFNZDUGPLQXWHV.
•
&KDQJHIRUPDW
You can switch the time display
format from 12 to 24-hour and vice
versa.
•
)RUZDUGPLQXWHV
You can put the time forward in
intervals of 30 minutes.
• %DFNZDUGPLQXWHV
You can put the time back in intervals
of 30 minutes.
X Press the rotary control/push button
to execute the relevant function.
Software update
A software update for your Traffic Pro
can be carried out by inserting a CD.
New functions for your Traffic Pro can
be provided by means of a software
update.
X Insert the software update CD into the
CD slot with the printed side up.
After a short time, the following display
appears:
X Select <HV to install the update or 1R to
continue without updating.
The software update starts when
<HV is
selected.
Note:
The menu item cannot be selected if
GPS reception is not available.
7051
Note:
Before carrying out an update, switch
the vehicle ignition on and leave it on
during the update.
The Traffic Pro cannot be used during
the software update.
7026