Becker Traffic Pro 7945 - System Settings Overview; Basic System Settings; Factory Reset Function

128
Settings
System settings
You can configure various basic settings
on your Traffic Pro to meet your require-
ments in the system settings.
The following possible settings are
available:
For
$XGLR:
• Setting for speed-dependent increase
in volume with
6SHHGGHSHQGHQWYROXPH.
• Using
,QVWDOODWLRQ SRVLWLRQ RI PLFURSKRQH,
you can specify whether your vehicle
is a left-hand drive or right-hand drive
vehicle.
• Setting for acoustic signal volume
with
9ROXPHRIZDUQLQJWRQHV
• You can use 'LVSOD\ YROXPH to select
whether a change in volume should be
displayed in graphics format.
• Setting for the volume level of digital
to analogue audio sources with
'LJLWDO
OHYHO
.
Other settings:
• Using
([WHUQDOGHYLFH, you can specify
whether an AUX source or an external
hands-free unit is connected to the
Traffic Pro instead of a CD changer.
• Setting display brightness with
'LVSOD\
EULJKWQHVV
.
• You can use 'D\QLJKWGHVLJQ to config-
ure the settings for changeover
between day and night design.
• You can use
5HVHWIXQFWLRQV to reset the
Traffic Pro to the factory settings.
• You can use
'LUHFWLRQRIURWDU\DFWXDWRU
to specify the direction in which lists
and menus are scrolled when the
rotary control/push button is turned.
•
&ORFN
You can configure the GMT time sent
by the satellite in terms of its format
and the current time zone.
The time only needs to be set so that the
Traffic Pro can supply navigation
information correctly on routes with
time-dependent route guidance. Setting
the time also ensures that anticipated
times of arrival are announced/
displayed correctly.