Becker Traffic Pro 7945 - Connecting a Device; External Device

119
Settings
Connecting a device (external
device)*
Connecting the Traffic Pro to an external
device can also be initiated by the
external device.
Two different scenarios will be
described below.
• The external device has previously
been connected to the Traffic Pro.
• The external device has not been
connected to the Traffic Pro before.
The external device has previously
been connected to the Traffic Pro*
When the external device attempts to
establish a connection, a signal tone can
be heard and the following message
appears.
X Select between <HV, 1R and $OZD\V.
•
<HV
Connection to the external device is
allowed.
• 1R
Connection to the external device is
rejected.
•
$OZD\V
Connection to the external device is
allowed. The function described in
“Always allow connection*” auf
Seite 116 will also be activated.
Further connection requests will be
accepted without a query.
If the connection to the external device
is established successfully, another
signal tone can be heard and the
following message appears.
X Press the rotary control/push button
.
A connection has now been established
to the external device.
Note:
If a device is already connected to the
Traffic Pro, the attempt made by the
external device to establish a
connection will be ignored.
Note:
If the function described in “Always
allow connection*” auf Seite 116 is
activated, a short signal tone can be
heard and a message appears which
confirms that the external device has
been connected.
7039
7040
*Only available for the Traffic Pro with Bluetooth® wireless technology.