Becker Traffic Pro 7945 - Managing Stopovers; Deleting a Stopover

48
Navigation mode
• (QWHUDGGUHVV
You can enter a complete address as a
stopover as described in “Entering a
destination” on page 27.
•
$GGERRN
You can enter an address book entry as
a stopover as described in “Selecting a
destination from the address book” on
page 38.
•
6SHFLDO'HVW
You can enter a POI as a stopover as
described in “Point of interest” on
page 39.
•
5DSLGDFFHVV
You can enter a fast access destination
as a stopover as described in “Naviga-
tion fast access” on page 35.
Once the stopover has been selected, the
route is recalculated and route guidance
started to the stopover.
Deleting a stopover
If you have entered a stopover, you can
delete it before reaching it.
X In the Options menu, select the 6WRS
RYHU
entry again.
X Select <HV (delete stopover) or 1R
(retain stopover).
If
<HV is selected, the stopover is deleted
and route guidance to the main destina-
tion started automatically.
Note:
Once the stopover has been reached, the
following display appears.
Route guidance to the main destination
is started automatically.
2071
2072
Note:
If no operator inputs are made, the
menu will automatically disappear after
a few seconds and the stopover will be
retained.