Patient Monitor User’s manual
2-2
Caution:
To ensure patient safety, use only parts and accessories specified in
this manual.
At the end of its service life, the monitor, as well as its accessories,
must be disposed of in compliance with the guidelines regulating the
disposal of such products. If you have any questions concerning
disposal of the monitor, please contact us.
Magnetic and electrical fields are capable of interfering with the
proper performance of the monitor. For this reason make sure that all
external devices operated in the vicinity of the monitor comply with
the relevant EMC requirements. Mobile phone, X-ray equipment or
MRI devices are a possible source of interference as they may emit
higher levels of electromagnetic radiation.
Before connecting the monitor to the power line, check that the
voltage and frequency ratings of the power line are the same as those
indicated on the monitor’s label or in this manual.
Always install or carry the monitor properly to avoid damage caused
by drop, impact, strong vibration or other mechanical force.
The American mains plug whose ground is in the same plug with its
other two cords is Hospital Only. The supply cord should be
connected to the sockets which are Hospital Only to achieve
grounding reliability.
Note:
Put the monitor in a location where you can easily see the screen and
access the operating controls.
Keep this manual in the vicinity of the monitor so that it can be
obtained conveniently when needed.
The software was developed in compliance with IEC 60601-1-4. The
possibility of hazards arising from software errors is minimized.
This manual describes all features and options. Your monitor may not
have all of them.
To Next Page
Loading...
Need help?
General
