iv | 405 LS Operator's Manual
Install the Vacuum Line Filter 21
Install the Fluid Supply System 22
Final Check 24
Attach the Mist Shield 24
Install Software/Connect to Computer 25
Connect to Host Computer 25
Connect to Power 26
Define Instrument Settings 26
LHC Users Only 26
Standard Vacuum Pump Users 27
Define Startup Preferences (LHC users only) 27
Verify Performance 29
Verify the Washer 30
Run the Verify Test ("Q" Models Only) 30
Repacking the 405 Washer 32
Operation 37
Basic Operation 38
About the 405 LS Wash Step 38
Optimize Performance 39
405 Recommendations for Priming the Washer 39
Optimize protocols to improve evacuation 40
Running Predefined Protocols 41
Creating Protocols: Washing, Aspirating and Dispensing Fluid 41
LHC Users Only: Customize the Predefined Protocols 41
Predefined Protocols Listing 43
Predefined Sample Protocols 44
Introducing the 405 LS Keypad 46
Quick Wash (Keypad only) 47
Quick Prime (Keypad only) 48
Create or Edit a Protocol (Keypad Only) 48
How to name a protocol (Keypad only) 49
Define the Plate Type and Plate Map (or Partial Plate) 50
How to shake the plate 51
How to enter negative numbers (Keypad only) 52
How to copy a protocol 52
How to delete a protocol 52
Using LHC to Control the 405™ Washer 54
Introducing the LHC Workspace 54
Communications Port 55
405 Steps 55
LHC Protocols 56
LHC Protocols Explained 57
Target Instrument Settings 58
How to define a Protocol (LHC only) 59
How to use the Adjust Utility- LHC 60
Upload-Download Protocols (LHC Only) 62
Wash Step Parameters Table 62
405™ Microplate Washer LS
To Next Page
Loading...
