Notices| v
Shake/Soak Step Parameters 66
Pre-Dispense 67
Washer Flow Rates 68
How to define a Final Aspiration step 69
Add a secondary aspiration to a wash cycle 70
Bottom Wash 70
Verify Performance 72
Handling the Verify Test Plate 73
Verify™ Technology Flowchart Diagram 75
Verify Test Corrective Action 75
About Verify™ Technology 76
Sensitivity: Verify Sensor vs. Absorbance Reader 78
Configure Verify™ Technology Utilities 79
Operating with the BioStack 81
BioStack Alignment Utility 82
Cell Wash 84
Cell Wash Strategies 85
Biomagnetic Separation - Magnetic Bead Assays 89
Perform Magnetic Bead Assays 90
Optimize Magnetic Bead Protocols 90
Flat Magnets 91
Ring Magnets 92
Magnet Height Offset 93
Determine Magnet Height Offset 93
Manifold Stop Screw Adjustment Kit 94
Vacuum Filtration for Filter Plate Assays 97
Install the side bracket 98
Set up the Vacuum Filtration module 99
Enable Vacuum Filtration 101
Create a Vacuum Filtration Protocol 101
Install Vacuum Filtration Plate Carrier 103
Control the Vacuum Level 104
Washer Settings 105
Change the Washer Manifold Setting (Keypad) 107
Change the Plate Carrier Setting (Keypad) 107
Change the Plate Clearance Setting (Keypad) 108
Adjust Utility 108
Run the Adjust Utility (Using the Keypad) 109
Plate Types and Processing Patterns 110
Plate Types Table 111
About Wash Processing Patterns 111
Maintenance 115
Overview 117
Recommended Maintenance Schedule 119
Daily Maintenance 121
Overnight/Multi-Day Maintenance 121
AutoPrime 122
BioTek Instruments, Inc.
To Next Page
Loading...
