Configuration Mode (ConF)
Code Nam e / De s cription Adjustment range Factory s e tting
MPC
*
nPr
[Motor param choice]
[M ot Pow e r]
(nPr)
[M ot Pow e r]
(nPr)
[M ot Cos ]
(COS)
(1) In corresponds to the rated drive current indicated in the Installation manual and on the drive nameplate.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Parameter that can be modified during operation or w hen stopped.
To change the assignment of this parameter, press the ENT key for 2 s.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > DRC- > ASY-
2 s
*
To Next Page
Loading...
