Configuration Mode (ConF)
Code Nam e / De s cription Adjustment range Factory setting
This parameter can be accessed if
[3 parameter sets]
(CHA2) is not
[No]
(nO) and if at least 1 parameter has been selected
in
[PARAM ETER SELECTION]
.
Identical to
[SET 1]
(PS1-)
page 230.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Parameter that can be modified during operation or w hen stopped.
Note:
We recom m end that a param eter set s witching test is carried out while stopped and a check is m ade to
verify that it has been perform ed correctly.
Som e param eters are interdependent and in this cas e m ay be restricted at the tim e of s witching.
Interdependencies between parameters m ust be res pected,
even between different sets
.
Exam ple: The highes t
[Low speed]
(LSP) m us t be below the lowes t
[High speed]
(HSP).
*
To Next Page
Loading...
