BLEMO ER24 Series - Page 99

Configuration Mode (ConF)
101
Code Nam e / De s cription Adjustment range Factory setting
Ibr
*

[Brake release I FW]
0 to 1.36 In (1) 0.0 A
Brake release current threshold for lifting or forward movement. See page 194.
Ird
*

[Brake release I Rev]
0 to 1.36 In (1) 0.0 A
Brake release current threshold for lowering or reverse movement. See page 194.
brt
*

[Brake Release time]
0 to 5.00 s 0 s
Brake release time delay. See page 194.
bIr
*

AUtO
[Brake release freq]
[Auto] (AUtO)
0 to 10 Hz
[Auto] (AUtO)
See page 195.
[Auto] (AUtO): Nominal value
bEn
*

[Brake engage freq]
[Auto] (AUtO)
0 to 10 Hz
[Auto] (AUtO)
Brake engage frequency threshold. See page 195.
tbE
*

[Brake engage delay]
0 to 5.00 s 0 s
Time delay before request to engage brake. See page 195.
bE t
*

[Brake engage time]
0 to 5.00 s 0 s
Brake engage time (brake response time). See page 195.
JdC
*

AUtO
[Jump at reversal]
[Auto] (AUtO)
0 to 10 Hz
[Auto] (AUtO)
See page 195.
[Auto] (AUtO): Nominal value
ttr
*

[Time to restart]
0.00 to 15.00 s 0.00 s
Time betw een the end of a brake engage sequence and the start of a brake release sequence. See page 196.
tLIM
*

[Motoring torque lim]
0 to 300% 100%
Torque limitation in motor mode, as a % or in 0.1% increments of the rated torque in accordance with the
[Torq u e incre m e nt] ( I ntP ) paramete r, page 216.
See page 216.
tLIG [Gen. torque lim]
0 to 300% 100%
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > SET-