NOTICE!
Improper cleaning of the Börger machine can lead to mal-
functions and damage!
— Do not use water jets.
— Do not use aggressive cleaning agents, solvents or sand-
paper, as these can damage the metallic and plastic surfaces,
casing coating and seals.
— Do not use metal objects such as scrapers and screwdrivers
for cleaning coated machine parts.
— Never clean sensitive components with hard scrubbing and
strong mechanical pressure.
— Do not use a vacuum cleaner or a hand brush with plastic
bristles etc. to clean electronic components because the pro-
duction of static electricity can damage the electronic compo-
nents.
NOTICE!
There is a danger of considerable material damage if the
limits are not complied with!
Failure to comply with the limits can cause permanent damage to
the Börger machine and its components.
— The values may neither exceed nor fall below the limits speci-
fied in
Ä
Chapter 3.3 “Technical data” on page 55 of the
standard operating manual and the specifications on the data
sheet.
— On Börger machines that operate with a frequency converter,
make sure that the operating speed is sufficiently below the
maximum permissible speed (for speed limit based on
machine configuration, see enclosed data sheet).
— Take all necessary precautions to ensure that the permissible
differential pressure between the inlet and outlet of the Börger
machine is not exceeded.
— Make sure that the pressure on the outlet does not exceed the
permissible pressure of the pipe system and the Börger
machine, and not overload the drive and its elastic connec-
tions.
— The temperature values according to the data sheet may not
exceed or fall below the limits. Double-check this.
Safety
BA-RC40_EN, 17.01.2024www.boerger.de / www.boerger.com40
To Next Page
Loading...