BradyPrinter S3100 Sign & Label Printer User’s Manual
85
Cleaning the Printer
Cleaning the Cutter Blade
4. Clean metal cutting blade [9]:
a. If the cutting blade shows significant residue, use the cutter cleaning tool
in the cleaning kit to gently scrape the reside off the cutting blade.
b. Moisten one of the foam swabs from the cleaning kit with the alcohol. Do
not allow the alcohol to drip from the swab.
c. Clean cutting blade with moistened swab until all residue is removed.
d. Clean beneath the edges of the blade housing with moistened swab. To
avoid forcing residue deeper into the machine, use motions from the outer
edge of the blade toward the center.
e. Continue cleaning until no residue is visible and clean swabs do not
become discolored.
5. Close the cutting blade by pushing up on the exit chute until the cutter tabs
snap into place.
Note: You may need to hold ribbon cover up slightly to access the exit chute.
6. Replace the ribbon and tape.
7. Close all covers and plug in the power cord.
To Next Page
Loading...
