BradyPrinter S3100 Sign & Label Printer User’s Manual
8
Unpacking and Setting up Printer
Setting up the Printer
Setting up the Printer
Connect Printer Power
To setup the printer:
1. Plug the power cord into the printer at the location shown.
2. Plug the other end of the power cord into an AC power outlet.
3. Turn the power switch on. The printer turns on and displays the Home page.
The size and color of the currently installed media and other status indicators
are shown.
Note: If there is no ribbon or media installed, the system defaults to black
ribbon and 4 in. [101.6 mm] wide continuous white media.
Power Cord
Connector
Power Switch
To Next Page
Loading...
