Brady BradyPrinter S3100 - Cleaning the Cutter Blade Exit Area

BradyPrinter S3100 Sign & Label Printer User’s Manual 87
Cleaning the Printer
Cleaning the Cutter Blade Exit Area
Cleaning the Cutter Blade Exit Area
This procedure cleans the cutter blade exit area and the exit chute.
Note: You should clean the exit area after cleaning the cutter blade and sensors.
The cleaning swab may be damaged when cleaning the exit area.
Materials Required
• BradyPrinter S3100 Cleaning Kit (Cat # B31-CCT)
• Isopropyl Alcohol
To clean the exit chute:
1. If necessary, remove power and media from the printer (see “Removing
Power and Media from Printer” on page 81).
2. Close the ribbon cover. It does not need to snap into place.
3. Using swabs from the cleaning kit moistened with alcohol, clean the exit chute
entrance [12] and exit chute ramp [13].
Note: To reach all areas of the exit chute, you can close the enclosure cover
and tilt the printer up on its side.
4. Replace the ribbon and tape.
5. Close all covers, plug in the power cord, and turn on the power switch.
12
13