BradyPrinter S3100 Sign & Label Printer User’s Manual
12
Unpacking and Setting up Printer
Setting up the Printer
3. Swing yellow media wiper [3] to far right (when facing display), if engaged.
4. Slide yellow media guides [4] to full-open.
5. Remove existing media, if installed, by pulling cartridge from printer.
6. Insert media cartridge until spindle ends rest in slots of media holder [5].
7. Feed media from top of roll until it sits just past the black rubber roller.
8. Close media guides until they touch edge of media liner with media under the
guides.
9. Move media wiper into position so it rests on media.
Note: Not all media requires the use of the media wiper. Engage the media
wiper only if needed for the supply installed.
10. Close and latch ribbon cover, then close enclosure cover.
11. If printer was asleep, press . The system detects the installed supplies,
sets background and foreground colors, indicates the label dimensions and
the amount of remaining supplies.
To Next Page
Loading...
